Edelbrock 2010 Instalační manuál stáhnout pdf (Strana 19)

Part #1574, 1575, 1576

Brochure #63-1574

Rev. 9/24/14 - QT

Edelbrock GM LS3 Supercharger System for

2010 and later Grand Sport Corvettes

Installation Instructions

Page 11

16. Use a 13mm socket and an extension bar to loosen

and remove the battery hold down.

17. Remove the battery and set it to aside.

18. Use a 7mm wrench to remove the four bolts retaining

fascia center.

19. Lift and support the front end of the vehicle using a

jack and appropriately load rated jack stands then loosen

and remove the lug nuts from both front wheels. Remove

the wheels and set them aside.

20. Use a panel puller to remove the 7 body pins on each

side that retain the inner fender wells. (Note: Some trim

packages use screws in place of pins along outer edge.)

21. Pull back the inner fender well to access the two

bumper studs on each side. Use a 10mm deep socket to

remove the nuts.

22. Disconnect the indicator and fog lamp electrical

connectors.

23. Remove the three screws and one body pin that retain

each front valance.

24. Remove the five 7mm and two 10mm nuts retaining

the fascia from below.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

Žádné komentáře

Edelbrock 2010 Instalační manuál Strana 19